
Sailor's Hitch
Sailor's Hitch -
Draws up without working to form a strong, secure hitch that
will not jam. It may be used as a way to tie a smaller rope to
a very large rope. (The smaller rope should pull left when
tied as shown here.) Push a bight through the final tuck to
form a Slipped Sailor's Hitch.
submitted by Kevin

Scaffold Hitch
Scaffold Hitch -
A first-class method of slinging a plank to make a platform
for such purposes as painting, etc.
Seizing - Definition. A binding or lashing of small
stuff for example, to secure an end to the standing part after
making a bend or hitch, to make an eye round a thimble, to
draw two ropes together, etc.

Shear Lashing
Shear Lashing - Two
spars lashed together at one end and guyed. Used for lifting
heavy weights
Shears or Shear Legs
- A lashing used to produce Shear Legs or,
alternatively a lashing to secure poles or spars end to
end.

Sheepshank
Sheepshank - A
knot tied in the bight for shortening a rope or taking up the
slack, without cutting it. It can also be used to protect a
weak, damaged or frayed section of the rope. See also Tom
Fool Knot.
Sheet - Definition. A rope used to trim the lower edge
of a sail.

Sheet Bend
Sheet Bend -
The most useful and practical knot for bending (tying) two
ropes together. Note that to be correct the two ends should be
on the same side of the knot. If the two ropes differ in
thickness, a Double Sheet Bend should be used.

Short Splice
Short Splice
- The best method of joining two ropes together end ofr
end, provided that the spliced rope does not have to reeve
through a block. It is stronger, more secure and more
permanent than any bend.
Sinnet - Braided
cordage, formerly always made by hand but now often by
machine. Its particular advantage, apart from being
decorative, is that is does not have the same tendency to kink
as laid rope.
Slipped Bend -
Definition. Any bend, hitch or knot in
which the final or securing tuck is made with a bight instead
of an end. By pulling on the end, the knot can then break and
release the load. Thus a 'Half Bow' is a Slipped Reef
Knot.

Slippery Hitch
Slippery Hitch -
A method of securing a load temporarily and ready for instant
casting off, in which a bight is simply held by the tension on
the standing part. Not to be confused with a Slipped
Hitch.

Snaking
Snaking - An
addition to plain whipping on a rope. It is added partly to
strengthen the whipping, particularly on large ropes, and
partly for devorative purposes.

Spanish Bowline
Spanish Bowline -
A double loop knot that is tied in the bight in which the two
loops are splayed. Formerly used at sea for lowering a man
from a height, or raising him aloft.

Square Lashing
Square Lashing -
The standard lashing used to fasten two spars or poles
together, not necessarily at right angles, where there is no
tendency for them to spring apart.
Standing Part -
Definition. That part of the rope which
is not actively in us in tying a knot, as distinct from the
bight and the end. See illustration under Bight.
Strap or Strop -
Definition. An endless loop of rope,
usually a length the two ends of which are spliced together;
used for slings, to hold a block or to fasten one to a rope
along its length. Also the rope (wreath) fixed round a wooden
block.

Surgeon's Knot
Surgeon's Knot -
This is a variation of the Reef
Knot in which an extra turn is taken at the start to help
prevent the knot from tending to loosen while being completed.
Used by surgeons for tying a ligature and by us for parcels,
etc.
Back to Top